You have no items in your shopping cart.
Stop & Waste Installation
|
Check Stop & Waste flow direction. Installing it backwards will cause it to leak continually. Test Stop & Waste prior to burying. *Check for leaks at "tee" and valve. *Check to see that valve shuts off. Use teflon tape on all threaded fittings Use a Stop & Waste cover or cut a notch 4 to 6 inches in drain pipe to slip over the valve to keep dirt out. CAUTION When cutting the service to the house to install the Stop & Waste, remove 1/2" to 3/4" section of service line only. Removing more may cause problems with fit and leakage. 
|