You have no items in your shopping cart.
Wire Connections
|
1- Locate wiring in the same trench as mainline or lateral lines.
Attach wire to underneath of pipe using electrical/duct tape or run
wire through 3/4" PVC as conduit. 2- It is most common to use the white wire as the common wire. 3- Connect the lines to the valves before connecting the transformer lines. 4- Always add expansion coils or loops in the electrical lines, and also add a foot of wire when you make a turn. 3M DBY 1- Twist wire nut on 2- Open cap on vial 3- Insert wire nut and wire into vial (all the way to the end) 4- Spread wire into notches 5- Close cap on vial Rain Bird ST-3 1- Insert wire into bottom of dri-connector 2- Twist wires together 3- Slide sleeve on wire and crimp 4- Fill dri-connector with PT-5S sealer 5- Insert cap 6- Wipe off any excess sealer Richdel Gel-tite 1- Twist wires together 2- Slide on sleeve and crimp 3- Spread wires 4- Snap Gel-tites together King Tech One-step 1- Insert wires 2- Twist on the one-step (the one-step is a wire nut with a silicone gel filled chamber which makes for tight and water-proof connection) *Always use a water-proof connector to hook-up your irrigation system's electrical lines. See electrical connection variations.
|